|
|
nwjm
|
-- 04-12-2024 @ 11:29 AM
|
| |
Is the 8-32 nut brass or steel? If steel is it cad. plated & is it 11-32" in diameter? Lastly is it taller than a hardware store nut?
|
|
|
3w2
|
-- 04-12-2024 @ 5:45 PM
|
| |
Round, slotted, and threaded special nut made of brass, at least double in height of a hardware store 8-32 square or hex nut.
|
|
|
nwjm
|
-- 04-13-2024 @ 7:02 PM
|
| |
Is the outside knurled or smooth? Also is the top slotted? thanks,
|
|
|
nwjm
|
-- 04-13-2024 @ 7:18 PM
|
| |
Does the thread go through the entire nut & the slot crosses the thread ? It must be as tall as the 8-32 stud or slightly taller so a screw driver will tighten the nut. thanks,
|
|
|
3w2
|
-- 04-14-2024 @ 5:22 AM
|
| |
The nut is not much taller than the stud on the coil, slotted on top, and smooth on the outside. You will need to cut a notch in the blade of a cheap flat blade screw driver to clear the stud on the coil when tightening.
|
|
|
nwjm
|
-- 04-14-2024 @ 1:03 PM
|
| |
Thank you, I now understand. Unfortunately there is not an original 32 v/8 close to me that I could look at. I will now machine one. Henry must have made extra money selling specialized screw drivers through his parts dept. He was a crafty business man! I wonder how many of his tool pouch screw drivers were altered? Also would you loose points? Something to think about.
|
|
|
40 Coupe
|
-- 04-15-2024 @ 4:41 AM
|
| |
Third Gen Auto sells the nut.
|
|
|
nwjm
|
-- 04-15-2024 @ 7:52 AM
|
| |
Thank you, I,m working on a fastener order for them but I,ll machine an emergency spare. If I use the diameter between the peaks of a conventional hex nut will I be close to the round diameter?
|
|
|
3w2
|
-- 04-15-2024 @ 3:13 PM
|
| |
Close enough for an emergency spare.
|
|
|
nwjm
|
-- 04-15-2024 @ 6:45 PM
|
| |
Thanks again. Will this special nut that I made tonight be close enough for a spare?
|
|
|
3w2
|
-- 04-15-2024 @ 10:53 PM
|
| |
Looks great!
|
|