| RAK402 | -- 06-13-2016 @ 12:22 PM |
|
I have acquired a nice set of running boards for my 40 Sedan. I also have a Bob Drake welt for the boards. I am not sure how to install the welt, or how the ends of it should be addressed. Also, should I glue the welt to the boards before I attempt to install them? Thank you all in advance!
|
|
| kubes40 | -- 06-14-2016 @ 5:38 AM |
|
The anti-squeak material (obviously) goes between the board and the frame rail. The bead goes upward. It may make it a bit easier to install by applying a dab of glue here and there to the material. Originally, the ends were simply cut off - no "finishing" was incorporated at all. Mike Kubarth
|
|
| RAK402 | -- 06-14-2016 @ 8:56 AM |
|
Thank you sir! Tomorrow's project will be to change out the running boards!
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=9775 |